Connecting up and putting into operation
9
TV and video recorder connection (VCR)
•
Connect-up the satellite receiver (TV Scart socket) and TV set with a Scart ca-
ble.
If your TV set has stereo capability, a Scart connection allows you to receive the
sound in stereo.
•
Connect-up the video recorder and satellite receiver (VCR Scart socket) again
using a Scart cable.
Decoder connection
You can also connect-up a decoder to the receiver for Pay-TV programmes.
No further setting is necessary for decoders that require a video signal and supply
a switching signal, such as Premiere decoder and Videocrypt decoder, for exam-
ple..
Important
With decoders that do not supply a switching voltage, the receiver must be pro-
grammed appropriately beforehand (see “The video menu” section in chapter “Pro-
gramming TV programmes“).
Also take note of the decoder specification!
•
Using a Scart cable connect-up the decoder to the decoder Scart socket.
Inserting batteries into remote control handset
•
Remove the cover on the rear of the remote control handset.
•
Insert both of the batteries supplied into the remote control handset.
Make certain that the batteries are inserted with the correct polarity!
•
Replace the cover again.
Note
Exhausted batteries are special waste and should not be disposed of with house-
hold refuse. Instead, hand them in to a collection centre for used batteries!
