Initial settings
24
22 kHz signal
In this menu entry, you specify whether the 22 kHz signal is to be used to switch
between a satellite‘s lower and upper frequency range (low/high) or to switch be-
tween two satellite positions (Pos. A/B).
22 kHz: High/Low: Freq. range 22 kHz
Low Off
High On
(Factory preset)
or
22 kHz:
Pos A/B
:
Orbit Pos. 22 kHz
1
and 3
Off
2
and 4
On
See also video setup menu, menu lines:
Polarisation and Orbit Position
Tone-burst and DiSEqC-signal
If more than four control criteria are needed in a receiving system, a
DiSEqC control signal is required.
Which of the two setting options is required: “
Tone Burst
“ or “
DiSEqC
“
depends on the components of the receiving system.
Thus take into account the specifications of the components present in the receiv-
ing system (switch-over matrices).
Tone burst
In the “Tone burst“ menu entry the following settings of the 22 kHz signal are pos-
sible:
Switching states on setting:
22 kHz signal →
High/Low
and
Tone burst →
Pos. A/B
:
Low
High
22 kHz
Off
On
Pos. 1 Tone burst
0
Pos. 2 Tone burst
1
Switching states on setting:
22 kHz signal →
Pos. A/B
and
Tone burst →
Opt. A/B
Pos. Tone burst 22 kHz
1
0Off
2
0On
3
1Off
4
1On
DiSEqC
The switching options are further extended with the DiSEqC signal.
For an optimal setting, it is essential to know the switching criteria of the receiving
system.
