5 • Setting the Remote Transmitter and Receiver
CAUTION: e remote control device complies with part 15 of the FCC rules.
Changes or modi cations not expressly approved by Hunter Fan Company could void
your authority to operate this equipment.
Operation is subject to the following two conditions:
1. is device may not cause harmful interference.
2. is device must accept any interference received, including interference that may
cause undesired operation.
WARNING: Use only the Hunter Fan speed control supplied with this fan.
5-1. IMPORTANT! Before you change the dipswitch settings, make
sure the battery is not connected to the transmitter.
Change the position of the dipswitches in the remote transmitter
and the receiver. Make sure that the dipswitches match in
the remote receiver and transmitter. If they don’t match, the
transmitter will not function.
5-2. Install the included 9-volt battery into the transmitter.
Setting Dipswitches
When two or more fans are located near each other, you may desire
to have the receiver/transmitter for each fan set to a di erent code,
so that the operation of one fan does not a ect the operation of the
other fans.
e dipswitches for the receiver are located on the at surface of the
receiver. e dipswitches for the transmitter are in the the battery
compartment.
Receiver Dipswitches
Transmitter Dipswitches
