7 • Installing the Canopy and Canopy Trim Ring
7-1. Holding the canopy, raise the fan o the hook.
7-2. Align the slots in the canopy with the tabs on the ceiling plate.
7-3. Raise the canopy over the ceiling plate. Rotate the canopy
clockwise until the tabs on the ceiling plate totally engage with
the slots in the canopy.
WARNING: When raising the canopy, make sure the antenna
from the receiver is not pinched between the canopy and ceiling
plate.
7-4. Partially install the three canopy screws into the canopy one at a
time. Once all three screws are in, tighten them securely.
7-5. Using both hands, push the canopy trim ring up to the top of the
canopy. e canopy trim ring will snap and lock into place.
Should you need to remove the canopy
trim ring, follow these steps:
1. Locate the small bumps on top of the
tabs.
2. Press rmly on opposite sides of the
ring towards the canopy. e tabs will
ex out releasing the trim ring from
the canopy.
Step 7-2
Canopy Trim
Ring
Canopy
Ceiling Plate
Step 7-3
Canopy
Screw
Steps 7-4 – 7-5
