Parameter Default Function
RX
Diversity
BG: On-Start
on Main
A: Main Only
How to handle antenna diversity when receiving packets from the Access Point.
Options are: Main Only (use the main antenna only), Aux Only (use the auxiliary antenna
only), On-start on Main (on startup, use the main antenna), or On-start on Aux (on startup, use
the auxiliary antenna).
The options for the RX Diversity parameter should be set, based on the antenna configuration, as follows:
Antenna Configuration RXDiversity
A Main and BG Main Main Only
A Main and A Aux On-start on Main
BG Main and BG Aux On-start on Main
Contact Technical Assistance if you have questions about the antenna(s) installed on your MX7.
Parameter Default Function
Frag
Thresh
2346
If the packet size (in bytes) exceeds the specified number of bytes set in the fragment threshold, the
packet is fragmented (sent as several pieces instead of as one block). Use a low setting in areas
where communication is poor or where there is a great deal of wireless interference.
Options are: Any number between 256 bytes and 2346 bytes.
RTS
Thresh
2347
If the packet size exceeds the specified number of bytes set in the Request to Send (RTS) threshold,
an RTS is sent before sending the packet. A low RTS threshold setting can be useful in areas where
many client devices are associating with the Access Point.
Options are: Any number between 0 and 2347.
LED Off
The LED on the wireless card is not visible to the user when the wireless card is installed in a sealed
mobile device.
Options are: On, Off.
Tray Icon On
Determines if the Summit icon is displayed in the System tray.
Options are: On, Off
Hide
Password
On
When On, the Summit Config Utility masks passwords (characters on the screen are displayed as an
*) as they are typed and when they are viewed. When Off, password characters are not masked.
Options are: On, Off.
Admin
Password
SUMMIT
(or
Blank)
A string of up to 64 alphanumeric characters that must be entered when the Admin Login button is
tapped. If Hide Password is On, the password is masked when typed in the Admin Password Entry
dialog box. The password is case sensitive. This value is masked when the Admin is logged out.
Options are: none.
Auth
Timeout
8
seconds
Specifies the number of seconds the Summit software waits for an EAP authentication request to
succeed or fail.
If the authentication credentials are stored in the active profile and the authentication times out, the
association fails. No error message or prompting for corrected credentials is displayed.
If the authentication credentials are not stored in the active profile and the authentication times out,
the user is again prompted to enter the credentials.
Options are: An integer from 3 to 60.
7-17
