Avalanche Update using File > Settings
Use these menu options to setup the Avalanche Enabler on the MX7. Always change settings and then save the changes
(reboot) before connecting to the network.
Alternatively, the Mobile Device Server can be disabled until needed (refer to the Wavelink Avalanche Mobility Center
User’s Guide for details).
Menu Options
Note: Your MX7 screen display may not be exactly as shown in the following menu options. Contact Technical Assistance
for version information and upgrade availability.
Connection
Enter the IP Address or host name of the Mobile Device Server. Set the order in which serial ports or
RF connections are used to check for the presence of the Mobile Device Server.
Execution Not available in this release. Use AppLock, which is resident on each Windows device.
Data Control when data is transferred between the device and the Mobile Device Server.
Server Contact Setup synchronization, scheduled Mobile Device Server contact, suspend and reboot settings.
Startup/Shutdown
Set options for Enabler program startup or shutdown. Replaced by Preferences and Taskbar tabs in
some versions of Enabler.
Preferences
Set options for Enabler startup or shutdown and logging. Replaces Startup/Shutdown tab in some
versions of Enabler.
Taskbar Set options for Taskbar. Replaces Startup/Shutdown tab in some versions of Enabler.
Scan Config
This option allows the user to configure Enabler settings using a special bar code that is created by
the Avalanche MC Console. Scan Config not currently supported.
Display
Set up the Windows display at startup, on connect and during normal mode. The settings can be
adjusted by the user.
Shortcuts Add, delete and update shortcuts to user-allowable applications.
SaaS Configure the Enabler to connect with Avalanche on Demand.
Adapters
Enable or disable network and wireless settings. Select an adapter and switch between the
Avalanche Network Profile and manual settings.
Status
View the current adapter signal strength and quality, IP address, MAC address, SSID, BSSID and
Link speed. The user cannot edit this information.
6-10
