A SERVICE OF

logo

Open as PDF
next previous
Ch 3: Installing Optional Devices
Hitachi PC VisionBase8450H/R Server 67
1. Set a SCSI ID for the internal CD-ROM.
Use the short bar to set the SCSI ID into the range of 0 to 6. Use a pair of tweezers for inserting and removing
the short bar.
The following table shows the correspondence between the SCSI IDs and the settings on the short bar. The short
bar is factory-set at 3.
Remove short bars between pins 11 and 12 and between pins 13 and 14. You need not set a
terminating resistor in internal CD-ROMs because a terminating resistor has already been installed
in the internal SCSI cable (for removable devices).
Be sure to set SCSI IDs so that there is no duplication within the group of SCSI devices connected
with the same internal SCSI cable.
Store the removed short bars properly.
SCSI ID Setting on the short bar
0
1
2
3
4
5
6