IN & OUT SETTINGS (FM VERSION) ENG
Page 32
12.4 ADJUSTING THE RDS / RBDS OUTPUT (RDS MODULE SETUP)
The level of generated RDS / RBDS signal and its status On/Off can be adjusted by means of the RDS Module
Setup menu.
Selection of the Data System to be used (RDS or RBDS) can be achieved from the SETUP page in the Pc
Control Software page, after connecting to a processor featuring the RDS/RBDS encoder.
RDS Encoder menu allows You to turn the encoder On and Off.
The RDS signal Level may be adjusted within the deviation range. Here below are presented some relations
between deviation and RDS signal level:
-37.5 dB D=1.0 KHz
-31.5 dB D=2.0 KHz
-28 dB D=3.0 KHz
-25.5 dB D=4.0 KHz
-23.5 dB D=5.0 KHz
-21.9 dB D=6.0 KHz
- The default
operating level is -31.5 dB, D = 2.0 KHz with an overall MPX level of 0 dBm
- The RDS signal is available on the MPX Out connector, blended together with the MPX signal.
Also see Section 12.3.3 for setting the overall MPX signal
The RDS On Split option allow / don’t allow the Falcon 15’s RDS signal to be output in MPX splitted session.
** Falcon 15 with RDS option installed – Ref to Chapter 2.1
