www.desatech.com
119304-01A8
INSTALLATION
NOTICE: This heater is intended
-
-
-
WARNING: Never install the
• in a recreational vehicle
• where curtains, furniture,
heater
• in windy or drafty areas
-
currents move heat to wall sur-
smoke, aromatic candles, clean-
Note: Your replace is designed to be used in zero
clearance installations. Wall or framing material
can be placed directly against any exterior surface
on the rear, sides, or top of your replace, except
where standoff spacers are integrally attached. If
standoff spacers are attached to your replace,
these spacers can be placed directly against wall
or framing materials.
Use the dimensions shown for rough openings to
create the easiest installation. See Built-In Fire-
place Installation, page 11.
IMPORTANT: Vent-free heaters add moisture to
the air. Although this is benecial, installing re-
place in rooms without enough ventilation air may
cause mildew to form from too much moisture. See
Air for Combustion and Ventilation, page 5.
IMPORTANT: Make sure the replace is level. If
replace is not level, log set will not work properly.
Use the correct gas type (natural or propane/LP)
for your replace. If your gas supply is not cor-
rect, do not install replace. Call dealer where you
bought replace for proper type replace.
-
This replace accepts a blower assembly with an
electrical cord. The electrical cord is ve feet in length.
You must locate replace within reach of a 120 volt
grounded electrical outlet. If not, you must install an
electrical outlet within reach of replace power cord.
The GA3555 outlet accessory may be used for built-in
applications with blower accessory installed.
INSTALLING HOOD
Install hood to rail already installed in replace as
shown in Figure 5, page 9. Use 3 Phillips screws
provided.
