www.desatech.com
119304-01A14
INSTALLATION
Continued
Installation Items Needed
• 5/16" hex socket wrench or nut-driver
• Phillips screwdriver
• sealant (resistant to propane/LP gas, not provided)
1. Remove replace screen. Remove two screws
that hold replace screen in place for shipping.
These screws are located near top of screen.
Discard screws. Lift replace screen up and
pull out to remove.
2. Remove screws that attach log base assembly
to replace (see Figure 19). Carefully lift up
log base assembly and remove from replace
(see Figure 19).
Note: If adding the G8005 series brick liner acces-
sory, install it now. Follow instructions in G8005
accessory kit.
3. Route gas line (provided by installer) from
equipment shutoff valve to replace. Route
exible gas supply line through one of the
access holes.
4. Attach the exible gas line to gas supply (see
Figure 20). Check tightness of exible gas
line attached to gas regulator of replace (see
Figure 20).
5. Check all gas connections for leaks. See
Checking Gas Connections, page 15.
6. Replace log base assembly back into replace.
Feed exible gas line into replace base area
while replacing log base assembly. Make sure
the entire exible gas line is in replace base
area. Reattach log base assembly to replace
with screws removed in step 2.
-
Figure 19 - Removing Log Base
Assembly From Fireplace
Figure 20 - Attaching Flexible Gas Lines
Together
Flexible Gas Line
from Fireplace Gas
Regulator
To Fireplace Gas
Regulator
Equipment Shutoff
Valve Provided by
Installer
To External
Regulator
Natural Gas
To Gas Meter
and connections, internal and
external to unit, for leaks after
WARNING: Never use an
-
