IP Configuration
IPv4 Management and Interfaces
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version) 275
17
• Mask—Configured IP address mask.
• Status—Results of the IP address duplication check.
- Tent at iv e—There is no final result for the IP address duplication check.
- Valid—The IP address collision check was completed, and no IP address
collision was detected.
- Valid-Duplicated—The IP address duplication check was completed,
and a duplicate IP address was detected.
- Duplicated—A duplicated IP address was detected for the default IP
address.
- Delayed—The assignment of the IP address is delayed for 60 second if
DHCP Client is enabled on startup in order to give time to discover DHCP
address.
- Not Received—Relevant for DHCP Address. When a DCHP Client starts
a discovery process, it assigns a dummy IP address 0.0.0.0 before the
real address is obtained. This dummy address has the status of “Not
Received”.
STEP 4 Click Add.
STEP 5 Select one of the following fields:
• Interface—Select Port, LAG, or VLAN as the interface associated with this
IP configuration, and select an interface from the list.
• IP Address Type—Select one of the following options:
-
Dynamic IP Address
—Receive the IP address from a DHCP server.
-
Static IP Address
—Enter the IP address.
STEP 6 SelectDynamic Address or Static Address.
STEP 7 If Static Address was selected, enter the IP Address for this interface, and enter
one of the following:
• Network Mask—IP mask for this address.
• Prefix Length—Length of the IPv4 prefix.
STEP 8 Click Apply. The IPv4 address settings are written to the Running Configuration
file.
