A-20
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix A XECfgParm.dat File Parameters
Understanding the XECfgParm.dat File Format
*.VSCNetworkPlacement Determines Cisco PGW 2200 Softswitch placement (AT or
IXC) and bias routing accordingly.
Values:
• Nanp_AT
• Nanp_IXC
• NULL
• 0
Default: NULL
Note If you do not set this property, all calls will route
according to called number or some other criteria,
not Carrier ID.
*.CallCutoffTimer Provides a global system-wide timer, which is started when
a call is answered and runs for the pre-configured time.
When it expires the call is released in both directions and the
call is cleared. This parameter is not dynamically
reconfigurable. You must restart your system.
Valid values:
• Hours: 0 (default), 1–48 (using hour as the unit)
• Minutes: 0, 1–2880 (using minute as the unit)
• Seconds: 0, 1–1728000 (using second as the unit)
Default: 0—Disables the timer.
Note You can override this value using the first data word
of the CALL_CUTOFF_TIMER result type.
*.CallCutoffTimerUnits Defines the unit of measurement used for the global
system-wide timer.
Valid values:
• 0 (hours) (default)
• 1 (minute)
• 2 (seconds)
cfgM.recovDbFile Storage location of the configuration manager recovery
information.
Default: ../var/cfgMRecovery
Note Do not change this value.
Table A-1 Cisco PGW 2200 Softswitch 9.x XECfgParm.dat File Configuration Parameters
Configuration Parameter Definition
