A SERVICE OF

logo

2-33
Cisco IE 2000 Switch Hardware Installation Guide
OL-25818-04
Chapter 2 Switch Installation
Installing the Switch
Step 3 Push the switch toward the DIN rail to cause the spring-loaded latch at the bottom rear of the switch to
move down, and snap into place.
After the switch is mounted on the DIN rail, connect the power and alarm wires, as described in the
“Connecting Alarm Circuits” section on page 2-34.
For configuration instructions about the CLI setup program, see the Appendix C, “Configuring the
Switch with the CLI-Based Setup Program.”
Note For instructions on how to remove the switch from a DIN rail, see the “Removing the Switch from a DIN
Rail” section on page 2-33.
Removing the Switch from a DIN Rail
To remove the switch from a DIN rail, follow these steps:
Step 1 Ensure that power is removed from the switch, and disconnect all cables and connectors from the front
panel of the switch.
Step 2 Insert a tool such as a flathead screwdriver in the slot at the bottom of the spring-loaded latch and use it
to release the latch from the DIN rail. See Figure 2-20.
Step 3 Pull the bottom of the switch away from the DIN rail, and lift the hooks off the top of the DIN rail. See
Figure 2-20.