2-17
Cisco IE 2000 Switch Hardware Installation Guide
OL-25818-04
Chapter 2 Switch Installation
Connecting to Power
Figure 2-8 Installing the Ground-Lug Screws (Two Single Ring Terminals)
Step 7
Attach the other end of the ground wire to a grounded bare metal surface, such as a ground bus, a
grounded DIN rail, or a grounded bare rack.
Connecting the Power Converter to an AC Power Source
These sections describe the steps required to connect the power converter to an AC power source:
• Preparing the AC Power Connection, page 2-17
• Connecting the AC Power Source to the Power Converter, page 2-18
Preparing the AC Power Connection
To connect the power converter to an AC power source, you need an AC power cord. Power cord
connector types and standards vary by country. Power-cord wiring color codes also vary by country. You
must to have a qualified electrician select, prepare, and install the appropriate power cord to the power
supply.
Note Use copper conductors only, rated at a minimum temperature of 167°F (75°C).
1 Ground cable
16TC
±12/24/48
0.5-3.0A
1
331555
