2-112
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 2 Alarm Troubleshooting
2.7.179 NOT-AUTHENTICATED
The No Startup Configuration condition applies to ML-100T-8 Ethernet cards and occurs when no
startup configuration file has been downloaded to the 15310-CL-CTX or CTX2500 card, whether or not
you preprovision the card slot. This alarm can occur during provisioning. When the startup configuration
file is copied to the 15310-CL-CTX or CTX2500 card, the alarm clears.
Note For more information about Ethernet cards, refer to the Cisco ONS 15310-CL and Cisco ONS 15310-MA
Ethernet Card Software Feature and Configuration Guide.
Clear the NO-CONFIG Condition
Step 1 Create a startup configuration for the card in Cisco IOS.
General ML-100T-8 provisioning parameters are located in the Cisco ONS 15310-CL and
Cisco ONS 15310-MA Ethernet Card Software Feature and Configuration Guide. The Guide also contains
information about where to find additional IOS information.
Step 2 Upload the configuration file to the controller card by completing the following steps:
a. In node view, right-click the ML-100T-8 Ethernet card graphic.
b. Choose IOS Startup Config from the shortcut menu.
c. Click Local > CTX and navigate to the file location.
Step 3 Complete the “Soft- or Hard-Reset an Ethernet or Electrical Card in CTC” procedure on page 2-153.
Step 4 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).
2.7.179 NOT-AUTHENTICATED
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: SYSTEM
The NOT-AUTHENTICATED alarm is raised by CTC (not by the NE) when it fails to log into a node.
This alarm only displays in CTC where the login failure occurred. This alarm differs from the
“INTRUSION-PSWD” alarm on page 2-78 in that INTRUSION-PSWD occurs when a user exceeds the
login failures threshold.
Note NOT-AUTHENTICATED is an informational alarm and is resolved when CTC successfully logs into the
node.
2.7.180 OOU-TPT
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: STSTRM, VT-TERM
