6. USING THE OPERATION PANEL AND FRONT PANEL
RH-9800
24
G. Setting the number of eyelet stitches
1. The number of eyelet stitches can be set to between 4
and 20 stitches in steps of 1 stitch.
2. Press the “Up” button (L) or the "Down" button (K) to
set the desired number of eyelet stitches.
* When the setting value is being changed, the
numerals appearing in the display will flash.
3. Press the ENTER button (N) to accept the new eyelet
stitch number setting.
* The display will stop flashing.
H. Setting the cutting space
1. The cutting space can be set to between -0.3 and 0.5
mm in steps of 0.1 mm.
Note: You cannot set the cutting space to a value
that would make the difference between the
knife position compensation and the cutting
space less than -0.7 mm.
2. Press the “Up” button (L) or the " Down" button (K) to
set the desired cutting space.
* When the setting value is being changed, the
numerals appearing in the display will flash.
3. Press the ENTER button (N) to accept the new cutting
space setting.
* The display will stop flashing.
I. Setting the knife position compensation
1. The knife position compensation can be set to
between -0.7 and +0.7 mm in steps of 0.1 mm.
* If you would like to move the knife closer to the
seam, set to a negative value; if you would like to
move it away from the seam, set to a positive value.
Note: You cannot set the knife position
compensation to a value that would make the
difference between the knife position
compensation and the cutting space less than
-0.7 mm.
2. Press the "Up" button (L) or the "Down" button (K) to
set the desired knife position compensation.
* When the setting value is being changed, the
numerals appearing in the display will flash.
3. Press the ENTER button (N) to accept the new knife
position compensation setting.
* The display will stop flashing.
1147Q
1146Q
(L)
(N)
(K)
1148Q
1149Q
(L)
(N)
(K)
1150Q 1151Q
(L)
(N)
(K)
