6. USING THE OPERATION PANEL AND FRONT PANEL
RH-9800
20
If the power is turned on and the RESET switch is then pressed, the feed bracket will move to the cloth setting position.
Operations such as selecting a program number, changing the operation mode and selecting the cutting method can
then be carried out.
6-2. Selecting a program number
A maximum of nine different eyelet shapes can be programmed.
1. Press the PROGRAM NUMBER button (1). (Check
which of the mode indicator illuminates.)
In automatic, feed or manual mode, the program
numbers are displayed in the program number
display window (2) in the following order each time
the button is pressed.
→ 1→ 2
9
Note: If cycle programs have been input, the
sequence will be as follows:
→ 1 → 2 9→ → → →
( indicates a cycle program.)
* In programming mode, the program numbers are
displayed in the program number display window
(2) in the following order each time the button is
pressed.
→ 1 → 2
9 → C
6-3. Changing the mode
1. Press the MODE button (1).
* The mode changes in the following order each time
the button is pressed.
→ AUTO → FEED → MANUAL → PROGRAM
Automatic mode is used for normal sewing.
Feed mode is used to move the feed bracket with
out sewing in order to check component positions.
Use the Manual mode to check the machine
operation when sewing by turning the upper shaft
pulley by hand.
Programming mode is used when setting
programs.
6-4. Changing the cutting timing
When "BEFORE" (cutting before sewing) is selected, the
knife operates before the buttonhole is sewn.
When "OFF" (no cutting) is selected, the knife does not
operate.
When "AFTER" (cutting after sewing) is selected, the
knife operates after the buttonhole is sewn.
1. Press the KNIFE button (1).
* The cutting timing changes in the following order
each time the button is pressed.
→BEFORE → OFF → AFTER
1128Q
(2)
(1)
1019Q
(1)
1129Q
(1)
