Filter
Top Products
Assembly 23
MAN0661 (8/10/2007)
ASSEMBLY INSTRUCTIONS
DEALER SET-UP INSTRUCTIONS
Assembly of this pick-up broom is the responsibility of
the WOODS dealer. It should be delivered to the owner
completely assembled, lubricated and adjusted for
normal conditions.
Keep hands and body away from pressurized
lines. Use paper or cardboard, not hands or other
body parts to check for leaks. Wear safety goggles.
Hydraulic fluid under pressure can easily penetrate
skin and will cause serious injury or death.
Make sure that all operating and service person-
nel know that if hydraulic fluid penetrates skin, it
must be surgically removed as soon as possible by
a doctor familiar with this form of injury or gan-
grene, serious injury, or death will result. CON-
TACT A PHYSICIAN IMMEDIATELY IF FLUID
ENTERS SKIN OR EYES. DO NOT DELAY.
Route hydraulic hoses carefully to prevent dam-
age. Hoses must not be twisted, bent sharply,
kinked, frayed, pinched, or come into contact with
any moving parts. Operate moveable components
through full operational range to check clearances.
Replace any damaged hose immediately.
Do not allow bystanders in the area when oper-
ating, attaching, removing, assembling, or servic-
ing equipment.
Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its compo-
nents in any way.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
INSTALL GUTTER BRUSH (OPTIONAL)
Pick-up brooms are designed to carry only one gutter
brush. Never install more than one gutter brush.
When using a gutter brush, only the main brush
sweeps in the over-the-brush direction.
1. Remove plugs from holes in either the right or left
side of the unit (depending on which side the gutter
brush is to be installed).
2. Attach gutter brush mounting plate (15) and
attachment plate (4) to broom hood using six cap
screws (13), lock washers (25), and flat washers
(22).
3. Insert pivot pin (40) into pivot assembly (5), place
pivot arm (3) over pivot assembly and align holes.
Secure assembly together using clevis pin (24) and
cotter pin (30).
4. Insert bushings (6) into each end of attachment
plate (4).
5. Slide pivot assembly into attachment plate and
secure using bushing (24) and roll pin (31).
6. Attach motor (14) to motor mount plate (7) using
four cap screws (18) and lock washers (26).
7. Attach brush head (1) to brush mounting plate (2)
using four cap screws (17), flat washers (22), and
lock nuts (27).
8. Attach motor mount plate to pivot arm using two
carriage bolts (20), flat washers (23), lock washers
(26), and hex nuts (28).
9. Attach brush assembly to motor using cap screw
(16), lock washer (25), and flat washer (22).
10. Attach swing stop bolt (19) and two hex nuts (29) to
the pivot arm.
11. Remove plugs from holes on the top side of the
broom hood. Attach chain plate (11) to hood using
three cap screws (16), lock washers (25), and flat
washers (23).
12. Attach chain (35) and quick link (36) to top of pivot
assembly and opposite end of chain to chain plate
on the side of the broom hood.
Install Hydraulic Hoses
Use Figure 16 or Figure 17 to install hydraulic hoses for
either right or left gutter brush application.
Complete Dealer Check List on page 22 before
delivering broom to the customer.
CAUTION