Filter
Top Products
Operation 13
MAN0661 (8/10/2007)
Run the sweeper with the skid steer at a slow idle.
Check for hydraulic leaks or other problems and make
corrections, if necessary, before using the sweeper.
During Use
Carry the sweeper low to the ground so that the opera-
tor has good visibility and stability. Avoid any sudden
movements. Avoid excessive downward pressure on
the brush sections to prevent excessive wear. A two to
four inch wide pattern for the broom is sufficient for
most applications. Ensure that the adjustment bolts are
equally adjusted in order to prevent an uneven wear
pattern.
Directing Debris
Observe wind direction. Sweeping with the wind makes
sweeping more effective and helps keep debris off the
operator.
Dirt and Gravel
To keep dust at a minimum, plan your sweeping for
days when it is overcast and humid, or after it has
rained. Also, sweep so the wind blows at your back or
in the direction the brush head is angled.
Low brush speeds and moderate ground speeds work
best for cleaning debris from hard surfaces. Brush
speeds that are too fast tend to raise dust because of
the aggressive sweeper action.
To sweep gravel, use just enough brush speed to roll
gravel, not throw it.
Heavy Debris
For two inches or more of heavy debris, medium/high
and ground speeds of less than five mph are recom-
mended.
Sweep path less than the full width of the broom.
Increase engine speed if debris becomes very heavy.
Transporting
When improperly operated, power unit can roll
over or upset. Use of rollover protective structure
(ROPS) with seat belt securely fastened will reduce
the possibility of injury or death if rollover or upset
occurs.
Always follow safety rules, carry low to ground and
travel slowly.
Only raise a load when dumping.
Dumping Loads
AVOID INJURY OR DEATH FROM POWER
LINES:
• Stay away from power lines.
• Electrocution can occur without direct con-
tact.
• Check clearances before raising implement.
• Do not leave the operator's seat if any part of
the tractor or implement contacts electric lines.
Transport to dumping location before raising. Only
dump load while on a firm level surface.
Slowly raise load to required dumping height. Rotate
pick-up broom forward to empty the bucket.
Figure 8. Dump Position
GUTTER BRUSH (OPTIONAL)
The gutter brush is for sweeping forward only.
When sweeping next to curbs or walls with a gutter
brush, only the bristle tips should touch the vertical sur-
face.
When not using the gutter brush for a short period,
raise it 1-2 inches (25-51mm) off the ground with the
tension chain. During extended periods of non-use,
unhook hydraulic hoses from the gutter brush motor,
remove the gutter brush assembly and connect
hydraulic hoses to run only the main.