Filter
Top Products
Dealer Service 21
MAN0661 (8/10/2007)
3. Place the second section on the core with the drive
pins on either side of tube 2. Make sure drive pins
angle downward (Figure 14).
Figure 14. Second Section
4. Put the third section on with the drive pins around
tube 3. Make sure drive pins angle upward.
5. Slide sections on until the core is full. Make sure to
alternate the tubes used and the direction of the
drive pins.
Assemble Unit
1. Attach the section retainer and bearing mounting
plate with previously removed hardware.
2. Lay core on ground. Lower body over core.
3. Attach bearing mounting plate with previously
removed hardware.
4. Reattach motor mount with previously removed
hardware.
NOTES