8
Window Installation (Fig. 4)
1. Make sure the exhaust hose is properly installed onto the portable air conditioner.
2. Open window or sliding door for approximately 5” (130 mm)
3. Adjust the length of the window kit to the same length and width of the opening of the window or the sliding door. Cut the window
piece if necessary to fit the length of your window or sliding door.
4. Place the window kit on your window or sliding door, with the exhaust hole as near to the portable air conditioner as possible.
5. Close the window or sliding door, on the window kit. For long term installation, you may screw the window kit into your window
frame.
6. Adjust the length of the exhaust hose and mount the window kit adaptor to the window kit.
NOTE: When using the window kit on a window or sliding door it will cause the window or sliding door not to be properly closed and
locked. Additional security measurements maybe needed.
Wall Installation
1. Make sure the exhaust hose is properly installed onto the portable air conditioner.
2. Make a hole of 5.3” (135mm) diameter in the wall.
3. Insert as much as exhaust hose as needed through the hole.
NOTE: Make sure to have a qualified professional to make the hole to avoid the possibility of injury or damage to the structure. Make
sure that the hole is covered when it is not used by the portable air conditioner.