Filter
Top Products
2 3
A
B
C
Part 1 Before Getting Started
1.1 Check package contents
Open the package and verify that the following items are included:
• Thermostat wallplate (A) and cover (B)
• 2 mounting screws and wall anchors (C)
• Wire Labels
• Installation Instructions and User Guide
Before getting started, please review the following
pre-installation checklist.
If any of the items shown above are missing from your package,
call White-Rodgers
™
customer service at 1-877-654-9394 before
returning the thermostat to your place of purchase.
✔ Do you have either oil or gas burning furnace?
✔ Do you have Hydronic Heating (steam or hot water radiators or
radiant fl oor heating)?
You will need the following tools:
✔ Flat-head screwdriver
✔ 2 AA alkaline batteries
You may also need:
✔ Hammer
✔ Drill with 3/16" (4 mm) bit
✔ Small pliers to bend wires
Typically, this is achieved by fl ipping a switch on the outside of the
furnace/air handler to the “OFF” position.
1.2 Answer questions about source of
heating in your home
1.3 Assemble tools
1.4 Turn off power to your heating and
cooling system
Do not turn the system back on until you have
completed the installation and set up of the thermostat.