White Rodgers 1F91-71 Thermostat User Manual


 
30
the wall and disconnect the battery. Wait
about one minute, then reconnect the bat-
tery. The thermostat will revert to the fac-
tory preset program until you reprogram the
thermostat. If you don’t want to reprogram
the thermostat immediately, press
SYSTEM
SWITCH
until OFF is displayed and replace the ther-
mostat on the wall. Then press
RUN
PRGM
to begin
the factory preset program. Or you may
reprogram the thermostat, then replace it
on the wall.
To prevent further static discharge prob-
lems, touch another object to release static
build-up before touching the thermostat.
See OPERATING YOUR THERMOSTAT.
7. Why won’t the setpoint temperature go
to the temperature I want?
In the AUTO mode, the highest heating
setpoint temperature you select must be at
least 1°F lower than the lowest cooling
setpoint temperature you select (for ex-
ample, if 70°F is your lowest selected cool-
ing temperature, you cannot select a heat-
ing temperature any higher than 69°F). If
such a conflict exists, you must set the
lowest cooling temperature higher in order
to set the heating temperature higher. To
set a lower cooling temperature, you must
select a lower heating temperature. See
PROGRAMMING YOUR THERMOSTAT.