Filter
Top Products
26
Enter Cooling Program
If outside temperature is below 50°F, we
recommend that you remove the ther-
mostat from the wall before proceeding
with the following steps to program cool-
ing temperatures. Personal injury or
property damage may occur due to air
conditioner compressor slugging. A
fresh 9 volt Energizer
®
alkaline battery
must be installed to perform off-wall
programming. Programming away from
the wall should prevent accidental com-
pressor operation. BE SURE SYSTEM
SWITCH IS SET TO OFF POSITION BE-
FORE REATTACHING THE THERMO-
STAT TO THE SUBBASE!
1. Press
SYSTEM
SWITCH
until COOL appears.
2. Enter your cooling program by following
the procedure for entering your heating
program.
CHECK YOUR PROGRAMMING
Follow these steps to check your thermostat
programming one final time before beginning
thermostat operation.
1. Press
SYSTEM
SWITCH
until HEAT is displayed.
2. Press and hold
VIEW
PRGM
to view the heating
period times and temperatures in se-
quence for weekday MOR, DAY, EVE,
and NHT, then for weekend MOR, DAY,
EVE, and NHT.
CAUTION
!