White Rodgers 1F87-0261 Thermostat User Manual


  Open as PDF
of 12
 
7
PROGRAMMING
PROGRAMMING YOUR THERMOSTAT
Thissectionwillhelpyouplanyourthermostat’sprogramto
meet your needs. For maximum comfort and efficiency, keep
the following guidelines in mind when planning your program.
• When heating (cooling) your building, program the
temperaturestobecooler(warmer)whenthebuildingis
vacant or during periods of low activity.
• Duringearlymorninghours,theneedforcoolingisusually
minimal.
Planning Your Program
Look at the factory preprogrammed times and temperatures
shown in the sample schedule. If this program will suit your
needs,simplypresstheRUN/HOLDbuttontobeginrunning
the factory preset program.
If you want to change the preprogrammed times and
temperatures, follow these steps.
Determine the time periods and temperatures for your program.
Youmustprogramfourperiodsforeach day. However,you
may use the same heating and cooling temperatures for
consecutivetimeperiods.Youcanchoosestarttimes,heating
temperatures, and cooling temperatures independently (for
example,youmayselect5:00AMand70°asthedaily1st
period heating start time and temperature, and also choose
7:00AMand76°asthedaily1st period cooling start time
andtemperature).
Use the table to plan your program time periods and the
temperatures you want during each period. Fill in the complete
table to have a record of your programs.
Entering Your Program
Set Current Time and Day
1. PressTIMEbuttononce.Thedisplaywillshowthehour
only.
EXAMPLE:
2. Press and hold either or until you reach the correct
hourandAM/PMdesignation(AMbeginsatmidnight;PM
beginsatnoon).
3. PressTIMEonceagain.Thedisplaywindowwillshowthe
minutes only.
EXAMPLE:
4. Press and hold either or until you reach the correct
minutes.
5. PressTIMEonceagain.Thedisplaywillshowthedayof
the week.
6. Press or until you reach the current day of the
week.
7. PressRUN/HOLDonce.Thedisplaywillshowthecorrect
time, day, room temperature and set-point temperature.
Enter Heating Program
1. MovetheSYSTEMswitchtoHEAT.
2. Press PRGM once. “Mo” (indicating Monday program)
will appear in the display. Also displayed are the currently
programmed start time for the 1st heating period and the
currentlyprogrammedtemperature(ashing).
EXAMPLE:
This display window shows that for the 1st Monday
period, the start time is 6:00 AM, and 70° is the
programmed temperature (this example reects factory
preprogramming).
3. Press
or to change the displayed temperature
toyourselectedtemperatureforthe1stheatingprogram
period.
SAMPLE
Heating/Cooling Schedule Plan (Factory Program)
ALL DAYS OF THE WEEK
Start Time
Temperature
1ST
2ND
3RD
4TH
1ST
2ND
3RD
4TH
Period
6:00AM
8:00AM
5:00PM
10:00PM
6:00AM
8:00AM
5:00PM
10:00PM
70F
62F
70F
62F
78F
85F
78F
82F
HEAT
COOL
Heating/Cooling Schedule Plan
PERIOD 1 PERIOD 2 PERIOD 3 PERIOD 4
HEAT COOL HEAT COOL HEAT COOL HEAT COOL
Time Temp Time Temp Time Temp Time Temp Time Temp Time Temp Time Temp Time Temp
Mon
Tues
Wed
Thur
Fri
Sat
Sun
 previous next