Filter
Top Products
4
l
Remove poly-foam block
by pushing at top
until bottom can be grasped with hand to
pull from cabinet (see Figure 4). Be careful
not to damage cabinet insulation.
5
. Install plastic drain-cup spout
(on cabinets
with side louvers only) into hole at rear of
cabinet. (See Figure 4.) Spout should be
facing downward through hole.
6
. Remove paper backing
from 3 seal strips and
attach them to the top flange as well as to the
right and left side of unit (see Figure 5).
7
l
Install unit into cabinet.
First, check tubing.
Realign tubing if it is rubbing adjacent tubes
or extending outside the flange of base unit.
Now slide unit into cabinet until it rests against
rear embossed stops (see Figure
4). Be careful
not to push against sharp fins and plastic parts.
Figure 5
/SEAL STRIP 7
8
. Ground unit to cabinet
by using green ground
wire attached to left-front corner of unit base
and in lower left-hand corner of cabinet.
Fasten wire securely to cabinet using hex
head screw and nut (see Figure 6).
9
l
If necessary, drill 3/16” diameter hole
in
cabinet for ground wire (see Figure 7). Place
remaining length of wire under front lip of
base behind plastic front panel.
10
l
Remove protective wrapping from control
panel. Place control panel in position
and
insert control knobs through holes in control
panel and onto control shafts (see Figure 7).
11
l
Attach front panel
by placing bottom edge on
clips and pushing top down, then in and up.
Figure 7