Filter
Top Products
Operating Your Air Conditioner
To obtain the best oossible results from vour air conditioner. it is imoortant that vou ooerate it
properly. This section tells you how to set the controls and how to direct the cooled air.
Electrical Shock Hazard
l Plug unit only into grounded electrical
outlet.
l Do not use an extension cord.
l Do not operate unit with the front panel
removed.
Failure to follow the above precautions
could result in electrical shock or
personal injury.
Starting your air conditioner
1. Set Exhaust Control
to CLOSED for
maximum cooling performance.
(See “Using the exhaust vent control”
on page 6.)
2. Set the Selector Control
to the desired
setting.
COOL-for cooling the room air
HEAT-for heating the room air
FAN ONLY-for circulating rmrn air
without cooling or heating it
3. Set the Fan Control
to the desired
setting. You can use either the ENERGY
SAVER or NORMAL FAN settings. (See
“Using the energy saver settings” below.)
LOW
- for sleeping comfort
MED - for normal cooling
QUICK COMFORT
- for fastest cooling
NOTE:
This product is not designed to be
used as a primary heat source. It is
intended for supplemental heating only.
HEAT mode operation is not recom-
mended when the outdoor temperature is
below 45°F.
IMPORTANT:
If you turn the air conditioner
off, or if the compressor turns off when you
lower the Thermostat Control, wait at least
3 minutes before turning the air conditioner
back on. If you don’t wait, you may blow a
fuse or trip a circuit breaker.
4. Turn the Thermostat Control
to a
mid-setting. You can adjust the air
conditioner’s cooling performance by
turning the Thermostat Control toward
COOLER for more cooling or toward
WARMER for less cooling. You will need
to experiment to find the setting which
suits you best.
Using the energy saver settings
Use the ENERGY SAVER settings when
you do not want the fan to run continuously.
Using these settings causes the fan to stop
when the compressor stops and saves
energy.
Set the Fan Control
to the desired setting.
LOW - for sleeping comfort
MED - for normal cooling
QUICK COMFORT
- for fastest cooling