Filter
Top Products
Using the Energy Saver Control
1. Choose the desired fan setting-either AUTO
FAN or NORM FAN.
AUTO
FAN....will save energy when normal
cooling and moisture removal are
not
needed. The fan will cycle on and off as the
thermostat turns the compressor on and off.
This saves the cost of electrical energy that
would be used to run the fan continuously.
It is normal
for the fan to turn on and off in
the AUTO FAN setting. The amount of time
the unit will be off depends on room
temperature and thermostat setting.
AUTO FAN
is not suitable when the weather
is extremely warm or humid or when there are
several people in the room.
NORM FAN....the
fan runs all the time even
though the thermostat will turn the compressor
on and off. Use NORM FAN during warm or
humid weather and for rooms that need to be
cooled constantly.
Using the Fresh Air/Exhaust Control
This control setting can be used to draw stale smoky
air from the room, or to draw fresh air from the outside
into the room.
1. To exhaust room air
Set control to
EXHAUST.
Set FAN SPEED
CONTROL to desired setting. Set the fan con-
trol to
FAN ONLY
if no cooling is desired.
2. To bring in outside air
Set control to
FRESH AIR.
Set FAN SPEED
CONTROL to desired setting. Set the fan con-
trol to
FAN ONLY
if no cooling is desired.
NOTE: Energy efficiency is decreased when
operating in either EXHAUST or FRESH AIR and
cooling at the same time.
Make sure the FRESH AIR/EXHAUST control is
returned to the OFF setting when only cooling
is desired.
3. To circulate room air
Set control to
OFF.
Set FAN SPEED
to
FAN ONLY
CONTROL