Filter
Top Products
GOLD GV SerGOLD GV Ser
GOLD GV SerGOLD GV Ser
GOLD GV Ser
. 3 — . 3 —
. 3 — . 3 —
. 3 —
UserUser
UserUser
User
’s’s
’s’s
’s
information manual information manual
information manual information manual
information manual
Part number 550-141-812/069912
Lighting instructions — 7200DERN gas valve
FOR YOUR SAFETY READ BEFORE OPERATING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO THE APPLIANCE
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
WHAT TO DO IF YOU SMELL GAS
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights
the burner. Do not try to light the burner by
hand.
B. Before OPERATING, smell all around the
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air
and will settle on the floor. See below.
C. Use only your hand to depress and move Selector arm on gas
valve. Never use tools. If the arm will not depress or move by
hand, don't try to repair it, call a qualified service technician.
Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control, which has been under water.
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
NOTE: Selector arm cannot be
moved to OFF unless arm is
pushed in slightly. DO NOT force.
85020
Selector arm
Robertshaw gas valve
model 7200DERN
1. STOP! Read the safety information above on this label.
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the appliance.
4. Remove jacket top panel.
5. This appliance is equipped with an ignition device which automatically lights the burner. Do
not try to light the burner by hand.
6. Depress Selector arm slightly and move left to OFF.
7. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you
smell gas, STOP! Follow "B" in the safety information above. If you don't smell gas, go to
the next step.
8. Depress Selector arm slightly and move right to ON.
9. Turn on all electric power to the appliance.
10. Set thermostat to desired setting.
11. If the appliance will not operate, follow the instructions "TO TURN OFF GAS TO
APPLIANCE" below and call your service technician or gas supplier.
12. Replace jacket top panel.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be performed.
3. Remove jacket top panel.
4. Depress Selector arm slightly and move left to OFF. Do not force.
5. Replace jacket top panel.
Before attempting to start the boiler, check the boiler pressure temperature gauge. If boiler and system are
full of water and properly pressurized, the gauge should read at least 12 psig on most systems. Operating the boiler
without proper water content will damage boiler and controls and could result in severe personal injury, death or
substantial property damage.