Filter
Top Products
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
33
DURING PROGRAMMING THE GARAGE DOOR
MAY OPERATE. KEEP PEOPLE AND OBJECTS
CLEAR OF THE MOVING DOOR TO PREVENT
DOOR DAMAGE OR POSSIBLE PERSONAL
INJURY.
NOTE: Programming failure can occur if the wall
station or transmitter is too close to the opener during
the programming sequence. There must be a
minimum of 6 feet between the wall station/
transmitter and the opener.
NOTE: The opener can be activated by up to 8 remote
transmitters, 2 wall stations and 2 keyless entries. If a
9th remote is programmed the first remote
programmed will be lost from memory. The same is
true if a third wall station or a third keyless entry is
programmed, the first will no longer be in memory
and will not operate the opener.
NOTE: Do not press any button on the wall station
or transmitter until instructed.
TRANSMITTER:
1. Press and release the PROGRAM button located
on the garage door opener. The red PROGRAM
STATUS light on the opener unit and the overhead
lamp will turn on and remain lit for one minute,
indicating activation of the learn mode.
2. Press one of the buttons on the transmitter you
wish to use to operate the door. The PROGRAM
STATUS light on the opener will turn on and off
three times indicating a successful learn.
3. Press the same button on the transmitter once
more to confirm operation. The opener will turn on
and move the door.
At this point you will be able to activate the opener.
WALL STATION:
1. Press and release the PROGRAM button located
on the garage door opener. The red PROGRAM
STATUS light on the opener unit and the overhead
lamp will turn on and remain lit for one minute,
indicating activation of the learn mode.
2. Press the light on/off button on the wall station.
The program status light will turn on and off three
times indicating a successful learn.
3. Press the light on/off button on the wall station
once more to confirm operation. The overhead light
will toggle from on to off and from off to on.
At this point you will be able to activate the opener.
Program Status
LED
Program
Button
Programming Wireless Wall Station(s)
Or Transmitter(s) to Opener
Tools Needed:
None
Right Side Of Opener
FORCE ADJ.
STATUS
SW
PROGRAM
WARNING
I
T
o
O
p
e
r
a
t
e
D
o
o
r
Press
Here
Light
Button
Wall Station
Large Button
Transmitter