Wayne-Dalton 3322B-Z Garage Door Opener User Manual


 
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
19
24
Installing Wireless Keyless Entry
(If Included)
Tools Needed:
Power Drill
5/64” Drill Bit
Phillips Head
Screwdriver
IMPORTANT: INSTALL ALL WALL
CONTROLS OUT OF THE REACH OF
CHILDREN AND IN A LOCATION WHERE THE
DOOR CAN BE SEEN BEFORE ACTIVATING.
Locate a convenient place to mount the
wireless keyless entry, that does not
interfere with the normal opening and
closing of the door. To keep keyless entry
out of the reach of children, measure and
mark a spot at least 5 feet up from the floor.
Use the drilling template located on Page 39
to determine hole positions. Drill 5/64” pilot
holes 3/4” deep at each screw location.
Snap open the wireless keyless entry case
with a coin. Secure keyless entry base into
wood framing using the two screws
provided. Snap the front case half back onto
the base. Remove paper backing from
instruction label and apply to a clean
surface inside garage.
NOTE: Two screws are included for
mounting to wood structures. Ensure proper
hardware is used for mounting to other
materials.
NOTE: After completing this step, continue
with page 27.
5’
Screws
Keyless Entry
Keyless Entry Base
Keyless Entry Front
Case