Filter
Top Products
will void the warranty and make
the pump inoperable.
Where a 2-prong wall receptacle is
encountered, it must be replaced with
a properly grounded 3-prong re cep ta -
cle installed in accordance with the NEC
and local codes and ordinances.
12. All wiring should be performed by a
qualified elec tri cian.
13. It is strongly recommended that this
unit is plugged into a Ground Fault
Circuit Interrupter (GFCI). Con sult a
local electrician for installation and
availability.
14. Protect electrical cord from sharp
objects, hot sur fac es, oil, and
chemicals. Avoid kinking the cord.
Re place or repair damaged or worn
cords im me di ate ly. Use wire of
adequate size to minimize voltage
drop at the motor.
15. Do not handle a pump
or pump motor with
wet hands or when
standing on a wet or
damp surface, or in
water.
16. Do not use an extension cord.
Do not
walk on wet area
until all power has been turned off. If
the shut-off box is in basement, call the
electric company to shut-off service to
the house, or call the local fire
department for instructions. Remove
pump and repair or replace. Failure to
follow this warning can result in fatal
General Safety
Information
(Continued)
replace all unused tools and
equipment.
c. Keep visitors a safe distance from
the work area. Make workshop
child-proof with pad locks, master
switch es, and by re mov ing starter
keys.
10. When wiring an elec tri cal ly driven
pump such as this, fol low all electrical
and safety codes, as well as the most
recent National Electrical Code (NEC)
and the Oc cu pa tion al Safety and
Health Act (OSHA).
Risk of electric shock!
Never connect the green
(or green and yellow) wire
to a live terminal!
11. This equipment is only for use on
120 volt (single-phase) and is
equipped with an ap proved 3-con -
duc tor cord and 3-prong,
grounding-type plug as shown in
Fig ure 2.
To reduce the risk of electric shock, the
motor must be securely and adequately
grounded. This can be ac com plished by
inserting plug directly into a properly
installed and grounded 3-prong,
grounding-type re cep ta cle (as shown in
Figure 2).
Risk of electrical
shock! This pump is
supplied with a grounding conductor
and grounding type attachment plug.
Use a grounded receptacle to reduce
the risk of fatal electric shock.
Never cut off the round grounding
prong. Cutting the cord or prong
Operating Instructions
electrical shock.
Installation
In any installation
where property
damage and/or personal injury might
result from an inoperative or leaking
pump due to power outages, discharge
line blockage or any other reason, use
a backup system(s).
STEP 1: INSTALLATION OF PIPE
A. Insert the discharge pipe or pipe
nipple into the 3/8” ID plastic tube.
Before removing
pump from its
mounting position for service, always
disconnect electrical power to pump
and control switch. For any work on
pump or switch, ALWAYS unplug the
power cord. Do not just turn off circuit
break er or unscrew fuse.
STEP 2: MOUNTING
CONDENSATE UNIT
A. Position the pump below the
evaporator drain and/or furnace
drain.
B. The pump can be installed to the
wall or side of the appliance using
the two mounting brackets. Refer to
Figure 3.
STEP 3: INSTALLATION OF
CONDENSATE DRAIN LINES
A. To prevent pipe blockage in the
reservoir, modify the end of pipe or
tubing as illustrated in Figure 4.
B. Plumb flexible tube or pipe from the
condensate drain, and from the
Grounding
Blade
Figure 2 - Grounding
2
Figure 3 - Mounting location
GFCI Outlet
Mounting
brackets
6 1/2” above floor
High efficiency
gas furnace