Filter
Top Products
— 6 —
2. Install two (2) hex head bolts per leg
assembly to secure broiler body onto leg
stand (Fig. 5). (Apply lock-tight to bolt
threads.)
Hex-head
Bolts
Figure 5
CASTER-EQUIPPED BROILERS
Broilers mounted on stands with casters must
use a flexible connector (not supplied) that
complies with the Standard for Connectors
for Movable Gas Appliances, ANSI Z21.69
.
CSA 6.16 and a quick-disconnect device that
complies with the Standard for Quick-
Disconnect Devices for use with Gas Fuel,
ANSI-Z21-41
.
CSA 6.9. In addition, adequate
means must be provided to limit movement of
the broiler without depending on the connector
and the quick-disconnect device or its
associated piping to limit broiler movement.
Attach the restraining device at the rear of the
broiler. If disconnection of the restraint is
necessary, turn off the gas supply before
disconnection.
BURNERS & CERAMIC BRICKS
a) Insert ceramic radiant brick ends at each
corner of the burner frame. Four are required
for each burner (Fig. 6).
b) Tilt ceramic radiant sideways to clear
burner and frame assembly, then lower
radiant into position with one flange resting
on burner ledge and one flange resting on
frame ledge.
c) Install the remaining radiants so 5 radiants
are located on each side of the burner.
Figure 6
GRIDDLE PLATE INSTALLATION
Put the griddle plate on top of the broiler. Duh.