Filter
Top Products
39
© 2013 Directed. All rights reserved.
1-Way
39
Button Auto Lock
When On, the remote control buttons lock if more than 20 seconds
lapses between button presses. If a button is pressed when locked, a
fault tone is emitted. To unlock the buttons; press the
button followed
by the
button, the buttons unlock and tones play to confirm.
Car Select
Car 2 must first be turned On (See Remote Features menu under Pro-
gramming). Press and hold the
button for 3 seconds. The remote
flashes the LED and beeps once or twice to indicate the selected Car
is 1 or 2, release the button for Car Select or continue to hold for
programming.
Release the
button, then press and release while the LED and
beeps continue to perform Car Select. Once the car is selected a com-
mand can be performed by pressing one of the command buttons.
Programming
To enter: Press and hold the button for 8 seconds, the remote emits
one long beep and turns the LED on, the programming main menu has
been accessed (see the following “Remote Features menu”).
To exit: Press and release the
button once, then press and hold the
button again. 1 short and 1 long beep is emitted for each step
back, the LED turns off when programming is exited.
1. Remote Features menu
After entering the programming mode: Press and hold the
button, 2 LED flashes and beeps indicate the remote features
menu is accessed and can be set. Press buttons indicated below,
1beep and flash turns the feature on, 2 beeps and flashes turns
the feature off.
• Autolock feature: Press
to turn on/off.