Filter
Top Products
Step 1
Step 1
Fill tank with cool tap water.
Replace tank cap. Tighten
by turning clockwise .
Place tank back on humidifier.
Fill Tank
Scent Pad
Turn tank upside-down.
Remove tank cap by turning
counter-clockwise
.
Once the filled water tank
has been placed on the unit
do not move humidifier.
Doing so could cause
leakage and spills.
SETTING UP YOUR HUMIDIFIER (cont’d.)
Output
Starry Night
Projector
Set fan speed to desired output:
High ( ) Max Moisture
Low ( ) Night time sound sleep mode
Step 1 Step 2 Step 3
Power
With the power switch in the OFF position, plug the filled
humidifier into a polarized 120V outlet. DO NOT FORCE THE
POLARIZED PLUG INTO THE OUTLET; it will only fit one way.
DO NOT plug in humidifier with wet hands to avoid
electric shock.
Turn the power switch to the on position to activate the starry
night projector
Note: Projector can be operated independently of the humidifier.
Step 1
OPERATING YOUR HUMIDIFIER
WARNING: Do not rub face or eyes after touching scent pad. Do not put fingers in mouth
after touching scent pad. Oils in the pad could act as an irritant to eyes.
WARNING: As long as your humidifier is on, the scent pad heater will also be activated. This
area can be warm to the touch.
INGREDIENTS: Eucalyptus Oil, Menthol, Glycol, Cedar Leaf Oil & Others
NOTE: Replace with Vicks Scent Pads, models VSP-19/VSP-19-CAN or Vicks Sleepy Time Vapopad
VBR-5, available at most retailers or through Kaz Consumer Relations or www.kaz.com.
Do Not Use Hot Water when Filling Humidifier
5