Verilux VH04WW1 Vacuum Cleaner User Manual


  Open as PDF
of 28
 
21
7. Care and Maintenance — continued
C
B
A
D
7.4 Sponge Filter
The Sponge Filter is located behind the HEPA-12 Pre-Filter attached to the Dirt Cup.
1. AccesstheSpongeFilterbyrstremovingtheHEPA-12Pre-Filter.
2. Grasp Sponge Filter and remove.
3. Holdlterundercoldrunningwatertoremovedirt.Squeezeltertoremoveexcess
water and allow to dry completely.
4. ReplacelterintoDirtCupwithproperorientation.
Note: Assure the Sponge Filter and the HEPA-12 Pre-Filter are installed properly before replacing the Dirt Cup into the Canister.
7.5 HEPA-12 Exhaust Filter
The HEPA-12 Exhaust Filter (A) is located under the Filter Access
Panel (B) on the back of the canister.
1. Remove the the HEPA-12 Exhaust Filter (A) by lifting up on
the Access Panel Tabs (C).
2. Graspthelterbythetab(D)andliftawayfromcanister.
3. Gentlytapthelterontheinsideofagarbagereceptacleto
remove excess dust and dirt.
4. Replacelterbyrstaligninglter’srearedgeinsidethelipof
therecessandthenrotatelterdownatintorecess(E).
5. ReplaceFilterAccessPanel(B)byrstaligningcapturetabs,
then pressing down on the two Access Panel Tabs (C) to
latch in place.
7.4
7.5
7.6 Replacement Filters
A Replacement Filter Kit is available for purchase. Please refer to the Replacement Part List in Table 7-1 on page 28.
E
VH04-MAN-2012_Web.indd 21 12/12/12 3:37 PM
 previous next