Filter
Top Products
HEADERASSEMBLY INSTRUCTIONS cont.
5. Attach the ballast to the power cord.
Use care to align the 4-pin plug
properly. DO NOT FORCE - the
power cord is designed to connect
only one way.
8
6. Plug ballast into a standard 120V 50/60Hz
outlet. Turn lamp on. The green LED
indicator (J) on center of the ballast
will illuminate. If not, please refer to the
troubleshooting section of this manual.
(See page 10)
Note: Green LED indicator will not illuminate
if lamp is turned off or bulb is removed.
WARNING: Do not block vents on ballast.
Vents are necessary for proper function of the
ballast; blocking them may cause overheating
of the ballast and increase risk of fi re.
ALWAYS lift your lamp
by the shaft
J
ATTENTION!
DO NOT lift the lamp by
the gooseneck