Filter
Top Products
HEADERASSEMBLY INSTRUCTIONS
1. Set lamp base on the fl oor and insert the
lamp shaft over the base support unit until
the screw holes line up as shown in Fig. 1.
Insert the screw using the tightening tool and
turn clockwise to tighten.
6
2. Hold upper shaft with one hand,
release ergonomic height adjustment
lever by gently pulling it upward as
shown in Fig. 2. Extend the upper shaft
approximately 12”. Lock lever by gently
pushing it downward. Once assembly
instructions are complete, raise or
lower upper shaft to desired height
by releasing and locking the height
adjustment lever.
Close-up of screw hole in
the lamp base
Fig. 1
Fig. 2