9
BULB REPLACEMENT INSTRUCTIONS
Step 5: Closing the Bulb Clips
Ensure the plastic bulb clips are
centered on the white protective
bands. Gently push on the upper
portion of the fl uorescent tube
until it slides snuggly into the
clear plastic clip. Close the clip
over the tube. The clip will click
when fastened. Repeat on other
side. (Figure 9).
Step 6: Replacing the Lens
Cover
Align the lens cover over the
open face of the unit with the
ClearWave
®
logo at the bottom of
the lamp. Place your thumbs one
inch beyond the grey handles
towards the center of the unit
while your other fi ngers grasp
under the lip of the grey handles
(see Figure 10). Pull outward
with your fi ngers while pushing
down on the lens with your
thumbs. Release your fi ngers to
snap the lens into place.
Plug your ClearWave
®
into an
electrical socket and turn it on to
ensure the bulbs were properly
installed into their sockets. If the
bulbs do not illuminate, ensure
the bulbs are fully seated into the
sockets.