Filter
Top Products
8
5 6
Pre-treating your carpets with
the pre-treatment wand and
solution (model V-027PT only)
R
emove solution tank cap.
C
AUTION
:
Do not overfill. You should leave
1-2 cm of air space.
Fill the tank with pre-treatment solution.
R
eplace the solution tank cap.
Return the solution tank to the
cleaner making sure the solution
tube lines up with the groove in the
back of the solution tank. Firmly
press the solution tube into the plug
opening of the solution tank.
4
9
7
Remove the clean water tank cap
and put in a safe place. Slowly fill the
clean water tank with hot tap water
(max 40
o
C) and replace the cap.
Return clean water tank by lining
up the grooves of the clean water
tank with the support posts on the
inside of the handle. Rock clean
water tank inward until it locks into
place.
8
9
Attach the pre-treatment wand to
the water supply port and press
firmly until it locks into place.
Pre-treating your carpets with
the pre-treatment wand and
solution (model V-027PT only)
V027_Rapide XL_aw 25/10/05 4:33 pm Page 4