Filter
Top Products
4
1
B
elt or brush removal
and replacement
1
. Loop the belt around the rear shaft.
2. Loop the top of the belt above the small
pulley and the bottom of the belt around the
lower small pulley.
3. Feed the entire belt over the first large pulley.
4. Loop the belt around the front large pulley
and rotate the front brushbar forward until the
belt is in place.
Note: Make sure the entire belt stays on top of
the first large pulley by lightly placing a finder
on top to guide it.
R
eturn the nozzle cover to the
original position.
Secure by replacing the two (2)
screws.
R
emove the screw that holds the
brushbar in place.
2
3 4
T
ilt cleaner of
f the carpet. Grasp
the brush bar and pull the right side
of its chamber.
Tilt the brushbar down to the
ground and remove the silver cap.
Slide the worn brushbar out of the
cleaner.
T
o install a new brushbar
. Feed the
brushbar through the opening until
the screw plate and screw hole are
lined up (as above).
Note: The black cap behind the
silver screw plate will be through the
hole.
Replace the silver cap to right side
of the brushbar. Lift the brushbar up
and align with the brushbar
chamber. Push the screw plate
towards the screw hole until the
flush and replace the screw.
24
25
5
B
elt or brush removal
and replacement
V027_Rapide XL_aw 25/10/05 4:34 pm Page 12