Filter
Top Products
16 CAC
25. Do assemble the chimney connector so that moisture that accumulates within the chimney will flow back toward the
heater.
26. Do remove the ashes from the heater regularly.
27. Do set the thermostat on “HI” and allow the heater to burn for approximately 15 minutes after fresh coal is added
before reducing the thermostat setting.
28. Do store coal in such a manner that wet and dry coal will not mix.
29. Do protect your hands with noncombustible gloves when loading the heater, removing ashes, etc.
30. Do keep the heater doors closed except when refueling the heater or removing ashes.
DON’TS
1. Don’t dry clothing or other articles on or near the heater.
2. Don’t store or place flammable liquids, gases, or other pressurized containers near the heater.
3. Don’t use gasoline, gasoline type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or intensify
a fire. Using these and other similar materials can cause an explosion within the heater.
4. Don’t use an unlisted, type B, or poorly constructed or maintained chimney to vent this heater.
5. Don’t use galvanized pipe, steel pipe less than 24 gauge, or pipe of a diameter smaller than 6 inches as a chimney
connector.
6. Don’t store ashes in combustible containers, not store them near combustible materials nor dispose of them until
they have completely cooled.
7. Don’t use power blowers or air circulation systems with this heater that are not specifically recommended in this
manual.
8. Don’t neglect to inspect regularly and maintain door gaskets and latching mechanisms to assure the intended
tightness of the fire chamber.
9. Don’t install the heater or chimney connector at clearances less than those specified in this manual.
10. Don’t install this heater where flammable or explosive materials or vapors are likely to be present.
11. Don’t install this heater in a chimney flue that is used by another appliance.
12. Don’t neglect to clean and inspect your chimney regularly.
13. Don’t operate this heater with the doors open.
14. Don’t use the heater with missing or damaged parts.
SAFETY NOTICE
In the unlikely event that your heater “overfires” ( a condition evidenced by elbows, stovepipes, and connectors glowing red
in appearance or otherwise discoloring), then your installation is subject to excessive draft created by either a chimney too
tall or too great in diameter in conjunction with its height, or some other factor of an indeterminate cause. In this event, you
should install a barometric draft regulator. Such installation will preclude any overfiring and/or any hazardous conse-
quences of potential overfiring.
Barometric Draft Regulators are generally available where you purchased your stove or may be ordered directly from
United States Stove Company at a nominal charge.
BAROMETRIC DRAFT REGULATOR
Model DR6
2001 Consumer Price:
$24.00 - Includes Shipping and Handling
WARRANTY CLAIM INFORMATION AND REPAIR PARTS
A heater warranty is included with this owner’s manual. For warranty claims, follow the instructions provided by the
warranty.
ORDER ALL YOUR REPAIR PARTS FROM YOUR DEALER BY SUPPLYING THE FOLLOWING INFORMATION:
1. Part Name 2. Part Number (Not Key No.) 3. Model Number of Heater 4. Quantity of Part(s) needed
SEE FIGURE 12 FOR REPAIR PARTS