Filter
Top Products
MACHINE SCREW
CABINET DOOR KNOB
The cabinet door knob is mounted on the
inside of the cabinet door to facilitate
shipping and must be removed and re-
installed for proper usage.
To get the cabinet door open, place
your hand under the cabinet frame (right
hand side of the cabinet door) and push
door out.
FOLLOW THESE INSTRUCTIONS FOR DOOR
KNOB ASSEMBLY:
1. Remove the machine screw and the
door knob.
2. Place the knob on the outside of the
cabinet door, re-install the machine
screw and tighten being careful not to
strip out the threads in the plastic handle.
NOTICE: The CB36 is standard equipment on the
model B2350B. If you wish to purchase an as-
sembly, you can contact your dealer for details
or get it directly from the U.S. Stove Company.
INSTALLATION
1. Remove the Panel (A) using tin snips or
knock out using a hammer and chisel care-
ful not to distort the mounting surface.
2. Attach the Blower Mounting Box (B) to the
rear of the unit using four(4) of the supplied
#10 screws.
3. Then mount the Blower Assembly with the
four(4) remaining screws.
OPERATION
1. Rotating the rheostat control
knob clockwise will turn ON the
blower.
2. When turned on, the blower
comes on HIGH, then as the
knob is rotated clockwise, the
blower speed reduces.
3. Rotate the knob counter-clock-
wise to turn OFF.
A
B
C
D
Follow these instructions to operate you unit safely when operating the feed door.
NOTE:
DURING OPENING AND CLOSING OF THE FEED AND ASH DOORS OF THIS HEATER, IT MAY
SEEM THAT THE FIT OF THE DOOR IS "TOO TIGHT". AS THE HEATER IS FIRED, THE GASKETING
"SETTLES" OR "SEATS" ITSELF IN THE DOOR. THE TIGHT FIT AT THE FACTORY AND BEFORE
THE HEATER'S INITIAL FIRING IS TO INSURE A GOOD SEAL AFTER THE GASKETING "SETTLES".
NOTE:
THIS NEW LATCHING MECHANISM MEETS CODES AND PROVIDES MORE
SAFETY FOR THE USER OF THIS STOVE.
1. Turn handle clockwise to the 12 o'clock
position (A), pull the door open until you
engage the second step (B).
2. Hold the door in that position for ap-
proximately 10 seconds.
3. Then to open door, turn the handle
counter clockwise to the 9 o'clock
position (C) and then continue to pull
the door open. (D)
4. To close and latch the door, reverse
steps 1 thru 4.
CAUTION! DO NOT OPEN OR CLOSE THE TOP WHEN THE HEATER IS HOT!
To open, grasp the top at the front or on each
corner and lift all the way up until the support
rod stops the motion. Then gently lower the top
allowing the support rod to settles in the cup,
holding the top open.
To Close, lift the top until the support rod is out
of the cup. Pull the rod forward and lower the
lid closed.
12 13
Caution! Route the Power Supply Cord
away from the heat source and out of high
trafc areas.