Filter
Top Products
In normal operation at full rate after 15 minutes the following flame appearance should be observed.
FLAMESFLAMES
FLAMESFLAMES
FLAMES
The flames behind log #1, and in between log #2, should be yellow with a blue base. (See Below,
Figure 12)
Figure 12. Flames - Natural Gas and LP GasFigure 12. Flames - Natural Gas and LP Gas
Figure 12. Flames - Natural Gas and LP GasFigure 12. Flames - Natural Gas and LP Gas
Figure 12. Flames - Natural Gas and LP Gas
Periodic CleaningPeriodic Cleaning
Periodic CleaningPeriodic Cleaning
Periodic Cleaning
• Do not use cleaning fluid to clean logs or any part of heater.
• Logs - Brush with soft bristle brush or vacuum with brush attachment.
• Vacuum loose particles and dust from the front and rear burner, control, and piezo.
• Inspect burner's and air intake hole. Remove lint or particles with vacuum.
• External case should be dusted and wiped with a wet soapy cloth.
Annual Cleaning/InspectionAnnual Cleaning/Inspection
Annual Cleaning/InspectionAnnual Cleaning/Inspection
Annual Cleaning/Inspection
• Inspect and clean burner air intake holes.
• Inspect and clean all burner ports.
• Inspect ODS pilot for operation and accumulation of lint at air intake holes.
• Verify flame pattern and log placement for proper operation.
• Verify smooth and responsive ignition of main burner and rear burner.
FLAME APPEARANCE
#1
#2
CLEANING / SERVICING
15