Filter
Top Products
NOTE: All troubleshooting items are listed in order of operation.
REMEDYREMEDY
REMEDYREMEDY
REMEDY
POSSIBLE CAUSEPOSSIBLE CAUSE
POSSIBLE CAUSEPOSSIBLE CAUSE
POSSIBLE CAUSE
When ignitor button is pressed, there is
no spark at ODS/Pilot.
• Ignitor electrode positioned wrong
• Ignitor electrode is broken
• Ignitor electrode not connected to ignitor
cable.
• Ignitor cable pinched or wet keep ignitor
cable dry.
• Broken ignitor cable
• Bad piezo ignitor
• Replace ignitor.
• Replace ignitor.
• Reconnect ignitor cable.
• Free ignitor cable if pinched by any metal
or tubing.
• Replace ignitor cable.
• Replace piezo ignitor.
• Ventilate room. Stop using odor-causing
products while heater is running.
• Locate and correct all leaks.
• Appliance burning vapors from paint, hair
spray, glues, etc.
• Gas leak.
Appliance produces unwanted odors.
• Not enough fresh air is available for ODS/
Pilot to operate.
• Low line pressure.
• ODS/Pilot is partially clogged.
• Open window and/or door ventilation
• Contact local gas company.
• Clean ODS/Pilot.
Appliance shuts off in use.
• Gas leak.
• Control valve defective.
• Locate and correct all leaks.
• Replace control valve.
Gas odor even when control knob is in
OFF position.
• Gas supply turned off or manual shutoff
valve closed.
• Control knob not in PILOT position.
• Control knob not pressed in while in Pilot
position
• Air in gas lines when installed.
• ODS/Pilot is clogged.
• Gas regulator setting is not correct.
• Turn on gas supply or open manual shutoff
valve.
• Turn control knob while in PILOT position.
• Press in control knob while in PILOT posi-
tion.
• Continue holding down control knob.
Repeat igniting operation until air is re-
moved
• Replace ODS/pilot assembly or get is
serviced
When ignitor button is pressed, there is
spark at ODS/Pilot, but no ignition.
• Control knob not fully pressed in.
• Control knob not pressed in long enough.
• Manual shutoff valve not fully open.
• Replace gas regulator.
• Press in control knob fully.
• After ODS/pilot lights, keep control knob
pressed in 30 seconds.
• Fully open manual shutoff valve.
ODS/Pilot lights, but flame goes out when
control knob is released.
TROUBLE SHOOTING
TT
TT
T
urn off and let cool befurn off and let cool bef
urn off and let cool befurn off and let cool bef
urn off and let cool bef
ore serore ser
ore serore ser
ore ser
vicing.vicing.
vicing.vicing.
vicing.
Onl Onl
Onl Onl
Onl
y a qualified sery a qualified ser
y a qualified sery a qualified ser
y a qualified ser
vice pervice per
vice pervice per
vice per
sonson
sonson
son
should sershould ser
should sershould ser
should ser
vice and repair heatervice and repair heater
vice and repair heatervice and repair heater
vice and repair heater
..
..
.
WW
WW
W
ARNINGARNING
ARNINGARNING
ARNING
OBSERVED PROBLEMOBSERVED PROBLEM
OBSERVED PROBLEMOBSERVED PROBLEM
OBSERVED PROBLEM
20