Filter
Top Products
USSC 19
MODEL 4027 & ASA7 - PARTS LIST
KEY
PART NO.
DESCRITION QTY.
1 40422 Cast Iron Legs 4
• 83507 3/8-16 x 1-1/4 Bolt 4
2 25096 Flue Collar 1
• 83431 Weld Tab 3
• 83045A Washer 3/8 i.d._7/8 o.d. 3
• 83432 5/16-18 x 1-1/2 Hex Bolt 3
3 25080B Door Latch 2
• 83508 5/16- 18 x 3/4 Bolt 2
• 83338 5/16- 18 Lock Nut 2
4 69338B Shaker Handle Assembly 12
* 40423 Complete Shaker Grate Assembly 1
5 83109 1/4-20 Square Nut 2
6 25079 Retainer, Cog 1
7 83227 1/4-20 x 1 Bolt 2
8 40408 Left Shaker Grate 1
9 40409 Right Shaker Grate 1
10 40407 Shaker Frame 1
11 40415 Cog, Grate 2
12 89066 Fire Brick (4-1/2 x 9 x 1-1/4 THK.) 12
13 69349 Ash Pan Assembly 1
14 25095 Ash Door - Painted 1
15 40437 Door Handle 2
16 83506 3/8 x 1-1/4 Roll Pin 2
17 40379 Draft Cap 1
18 83503 3/8-16 x 2-1/2 Carriage Bolt 1
19 83274 3/8-16 Lock Nut 1
20 83443 Door Pin 4
21 25094 Feed Door - Painted 1
22 891053 Door Glass 1
• 891067 Door Glass w/ Ashley Logo
(For Model ASA7) 1
• 88087 Glass Gasket 2.5 ft
• 88066 5/8” Rope Gasket 3.375 ft
23 25178B Top Glass Retainer 1
24 25179B Bottom Glass Retainer 1
25 25180B Side Glass Retainer 2
• 83202 10-24 x 3/8 Machine Screw 8
26 88057 1/2” Rope Gasket 4.5 ft
• 89574 Spring Handle 3
• - Not Shown
Feed Door Glass Replacement
The fuel feed door is equipped with heat resistant ceramic glass that will withstand temperatures well beyond the heater's
operating range. Reasonable care, however, must be taken to prevent damaging the glass. Striking, slamming, or closing
the door against the wood fuel could cause cracking or breakage of the glass. Cracked glass can break suddenly when
heated. Do not use the heater with cracked or broken glass. Clean glass only when the heater is cooled off. Do not use
abrasive cleaners, use Windex, soap and water, etc. If the glass must ever be replaced, replace it only with glass
provided by the heater's manufacturer.
To replace the glass:
1. Obtain correct glass. If the glass gasketis damaged, it must be replaced as well.
2. Remove screws which secure the glass retainers to rear of fuel feed door. Then carefully remove the glass retainers,
old glass, and glass gasket.
3. Postion gasket snugly around entire perimeter of new glass.
4. Place the new gasketed glass against rear of fuel feed door and secure in place by reinstalling