Filter
Top Products
Wireless remote controller kit
Installation Manual
–11–
8 HOW TO SET THE ADDRESS SWITCH
• When the multiple Signal receiving units are installed in the same room, an address can
be set to prevent cross communication.
• When replacing the battery and pushing ACL button, the address of the remote controller
becomes [ALL] and the Signal receiving unit is enabled to receive signal regardless of
setting of address switch of the operation section.
• For selecting of the remote controller address, refer to Owner’s Manual.
• Change the address of the Signal receiving unit by removing screws of P.C. board cover
of the Signal receiving unit. After then, fix the cover with screws using a clamp.
The address switch is inside the cover of Signal receiving
unit.
Contact the dealer for setting of the switch.
Turn the switch to left for 1, 2 and 3, and right for 4, 5
and 6.
9 SLIDE SWITCH
• Check the slide switch in the battery box of the remote controller is set to [S] / [A] as factory
default.
Display of remote
controller address
Address Address Address
Address
Address switch position
of Signal receiving unit
Address switch
of Signal
receiving unit
can be set any
position.
A
1
3
2
4
6
5
Face plate
Remove
Screw
A
Select of operation mode set to A.
Slide
switch
position
Select of louver indication set to S.
11-EN
+00EH99677601_01EN_remo_IM.book Page 11 Thursday, October 8, 2009 4:12 PM