Filter
Top Products
– 93 –
Is PMV under correct conditions?
Is compressor under correct conditions?
Is AC mains voltage correct?
198 to 264V
Is connection of CN601 correct?
Is resistance value of TD sensor correct?
Is there gas leak?
Is there refrigerant shortage?
Is AC mains voltage correct?
198 to 264V
Correct wires
Check outdoor P.C. board.
Defect → Replace
Are connections of wires correct?
Between power cable and terminal block
Between outdoor P.C. board and terminal block
Correct
power supply line.
Compressor trouble
Rare short check
Defective → Replace
Check outdoor P.C. board.
Defect → Replace
Repair defective position.
Recharge refrigerant.
Repair defective position.
Replace defective part.
Does an abnormal overload happen?
Remove and improve
the cause of overload.
Correct connector.
Sensor error → Replace
Check outdoor P.C. board.
Defect → Replace
Confirm power supply
construction, etc.
Check outdoor P.C. board.
Defect → Replace
YES
YES
YES
YES
NO
YES
NO
YES
NO
NO
NO
YES
NO
YES
NO
NO
Check
code
[H03]
APPLICATION CONTROL KIT
LED display
D01 D02 D03 D04
(Red) (Yellow) (Yellow) (Yellow)
¥¥
ll
Check / Countermeasures
(Part without special mention indicates a part of the outdoor unit.)
[Power supply error, Current detection circuit error]
[Power supply error, Current detection circuit error]
[Discharge temp. error]
[Power supply error (Voltage error)]
[Power supply error (Voltage error)]
→ Refer to columns [H03] and [P04] and then check power supply and
voltage error.
LED display legend:
l
Go off,
¡
Go on,
¥
Flash (5Hz)
D01 D02 D03 D04
(Red) (Yellow) (Yellow) (Yellow)
¡
ll
¡
or
l
¥¥
l
D01 D02 D03 D04
(Red) (Yellow) (Yellow) (Yellow)
l
¡¡
l
D01 D02 D03 D04
(Red) (Yellow) (Yellow) (Yellow)
¡
ll
¡
D01 D02 D03 D04
(Red) (Yellow) (Yellow) (Yellow)
¥¥
ll
or
¡
ll
¡
[L29]
[P03]
[P04]
[P05]
<In case of SP40 to 56>