Toshiba RAV-SP240CT-UL Air Conditioner User Manual


 
–28–
Under Ceiling Type
Installation Manual
EN
Toshiba
Wireless remote control
Procedure 1
Turn on the circuit breaker of the air conditioner.
The operation is not accepted for 5 minutes when
circuit breaker is turned on at first time after installation,
and 1 minute when circuit breaker is turned on at the
next time and after. After the specified time has
passed, perform a test operation.
Procedure 2
Push “ON/OFF” button on the remote control, select
[COOL] or [HEAT] with “MODE” button, and then select
[HIGH] with “FAN” button.
Procedure 3
Procedure 4
Procedure 5
Procedure 6
Repeat procedures 4 5 4 5.
Indicators “Operation” (green), “Timer” (green), and
“Ready” (orange) in the wireless receiver section flash
in approx. 10 seconds, and the air conditioner starts
operation. If any of these indicators does not flash,
repeat procedures
2 to 5.
Procedure 7
Upon completion of the test run, push “ON/OFF” button
to stop operation.
<Overview of test run operations using the
wireless remote control>
Cooling test run:
ON/OFF 64 °F (18 °C) 66 °F (19°C) 64 °F
(18°C) 66 °F (19°C) 64 °F (18°C) 66 °F (19°C)
64 °F (18°C) (test run) ON/OFF
Heating test run:
ON/OFF 86 °F (30°C) 84 °F (29°C) 86 °F
(30°C) 84 °F (29°C) 86 °F (30°C) 84 °F (29°C)
86 °F (30°C) (test run) ON/OFF
Cooling test run Heating test run
Set the temperature to 64°F
(18°C) with the temp. setup
buttons.
Set the temperature to 86 °F
(30°C) with the temp. setup
buttons.
Cooling test run Heating test run
After confirming a signal
receiving sound “beep”
immediately set the
temperature to 66 °F (19°C)
with the temp. setup buttons.
After confirming a signal
receiving sound “beep”
immediately set the
temperature to 84 °F (29°C)
with the temp. setup buttons.
Cooling test run Heating test run
After confirming a signal
receiving sound “beep”
immediately set the
temperature to 64 °F (18°C)
with the temp. setup buttons.
After confirming a signal
receiving sound “beep”
immediately set the
temperature to 86 °F (30°C)
with the temp. setup buttons.
3, 4,
5, 6
2,7
2
2
Always select
[HIGH] fan
speed.
28-EN
+00EH99864801_00Ta.book Page 28 Tuesday, November 24, 2009 5:40 PM