Filter
Top Products
– 77 –
Concealed Duct High Static Pressure
Owner’s Manual
Concealed Duct High Static Pressure
Owner’s Manual
5 TIMER OPERATION
• Three timer modes are available: (Setting of up to 168 hours is enabled.)
Off timer : The unit stops when the set time is reached.
Repeat Off timer : The unit stops daily when the set time is reached.
On timer : The unit starts when the set time is reached.
Set
1 Push button.
The timer mode changes with every push of the button.
•
and timer display flashes.
2 Push to select “set time”.
• With every push of button, the set time
increases by 0.5 hr (30 minutes).
When setting a time more than 24 hours for timer
operation, timer can be set in increments of 1 hr.
The maximum set time is 168hr (7 days).
The remote control displays the set time with time
(between 0.5 and 23.5 hours) (∗1) or number of days
and time (24 hours or more) (∗2) as shown below.
• With every push of
button, the set time
decreases by 0.5 hr (30 minutes)
(0.5 - 23.5 hours) or 1 hr (24 - 168 hours).
Example of remote control display
• 23.5 hours (∗1)
• 34hours (∗2)
shows 1 day (24 hours).
shows 10 hours. (Total 34 hours)
3 Push button.
• icon disappears and time display goes on,
and
or icon flashes.
(When On timer is activated, time and On timer
are icons and other icons disappear.)
4 Cancel timer operation
Push
button.
Timer icon disappears.
NOTE
• When the operation stops after the timer reached the
preset time, the Repeat Off timer resumes the operation
by pushing
button and stops the operation after
the time of the timer has reached the set time.
• When you push
while the Off timer function of
the air conditioner is active, the indication of the timer
function disappears and then appears again after about
5 seconds.
This is due to normal processing of the remote controller.
1
3
2
4
(Off timer) (On timer)(Repeat Off timer)
No display
Off Off On
Number of days Time
6 POWER SAVING MODE
• The power saving mode saves energy by limiting the maximum current which will effect heating or cooling capacity that
the unit can generate.
Push button during operation.
• The air conditioner enters power saving mode.
•
appears on the display.
Power saving mode will stay in effect until it is cancelled.
To cancel the power saving mode, push
button again.
• disappears.
NOTE
• When other electric appliances are used at the same time, to avoid triggering the circuit breaker, power saving mode is
recommended. Of course you can use power saving mode to save energy as well.
• Power saving mode consumes less energy, but may not heat/cool the room as much as normal mode.
(The maximum current is limited to approximately 75% (factory default) of the normal mode.)
• To adjust the power-save settings, see “Power saving mode” in ADVANCED SETTINGS.
• Even when operation start/stop, operation mode change, or power reset is performed during the power saving mode, the
power saving mode is retained until the next operation.
– 13 – – 14 –